by Craftbits (Shellie Wilson)
What you need
6-LARGE JUICE CANS
SCRAP 1/4" & 1/2" WOOD
FLAT HEAD SCREWS
He used large juice cans(we worked in a geriatric center and had ready supply).
Open one end with can opener and bend all sharp edges in (you can file off all burrs).
Next wash and thoroughly dry.
Take 6 cans, form circle with 5 and one in center (or form all in circle).
He soldered at tops and bottoms and file off burrs.
Use thin 1/4″ scrap wood for top and use 3/8″-1/2″ scrap wood for bottom.
Lay cans on wood and trace outline and cut around each arc.
Paint/stain or attach material to bottom. Same with top (can add batting or foam and cover with material).
Paint cans or glue fabric or use contact paper to sides making sure you trim well.
For bottom place NAS in position and screw with flat screw through bottom of cans into wood.
For top you can cut second piece of wood in shape of inside diameter of cans and screw to top this will act like a seal.
You can also use a hinge for the top attach to can and wood. Decorate any way you want, finish all raw edges by sanding add braid tassells etc.
The ones we all had with the 6-cans/1 in the center we used as sewing cans and they looked so cute cause you could stuff a lot in them.
The ones in a circle make a great hassock you could put small balls to act as legs.
He did some with handles and even made some with Campbell soup cans put handle on for little girls church purse.
Good luck. Hope this helped!
Have You Seen These Ideas?