Heat Embossing With Craft Stamps

What this technique you can make raised and shiny stamped images.

by Craftbits (Shellie Wilson)

What you need

Ink pad
Embossing powder
Heat gun or Hair dryer


Ink the stamp and stamp it onto your project.

While the ink is still wet sprinkle the embossing powder over it.

Tap the excess powder off your project and carefully pour it back into your container as it can be re-used.

Preheat the heat gun for a few seconds and holding it around 4 inches away from your project hold it above the powder to melt it into your design for around 10-15 seconds.

It will melt, rise up and become shiny.

Allow the stamp to cool before touching it, as it will be hot.

Have You Seen These Ideas?