Cluster Bracelet

Step 1 – Attach clasp to one end of chain.

by craftbits (shellie wilson)

What you need

7-8" large link sterling chain
1 large lobster clasp
1 100pc package of 1 1/2" thin headpins
Assorted beads: 200-300, including spacers
Tools required:
Chain-nose plier
Round-nose plier
Wire cutter

Instructions

Step 2 – Add 1/2″ of beads to headpin.

Step 3 – Grip headpin wire with the tip of the chain-nose plier just above the beads and bend to a 90ý angle.

Step 4 – Using the round-nose pliers turn the wire up and around to form a loop, bringing the wire back to a right angle.

Step 5 – Slip the loop into the link of the chain.

Step 6 – Using the chain-nose plier, hold loop and wrap the wire several times around until it reaches the base of the bead. Remember to keep the wire at a right angle while wrapping. This will ensure an even coil.

Step 7 – Trim excess wire, and tuck the end down with the chain-nose plier. This can be tricky – use the tip of the plier on the tip of the wire and gently press into the direction of the coil.

Step 8 – Repeat the process until desired fullness is achieved. Usually 2 dangles from each chain link.

This project was contributed by Beadstudio.com Visit their website for beading supplies, projects, classes and articles

Have You Seen These Ideas?

Comments


CraftBitsStaff
CraftBitsStaff
New Comment
4
CraftGossip
EditorCraftGossip
New Comment
13
CraftGossip
EditorCraftGossip
New Comment
10
CraftGossip
EditorCraftGossip
New Comment
6
Craftbits.com
EditorCraftbits.com
New Comment
8
CraftBits Staff
EditorCraftBits Staff
New Comment
4
CraftGossip
EditorCraftGossip
New Comment
5
  • 1
CraftGossip
EditorCraftGossip
New Comment
5
Craftbits.com
EditorCraftbits.com
2