Beaded Watch Strap

Convert a simple watch into a beaded masterpiece with these simple step by step instructions.

by craftbits (shellie wilson)

This Watch strap uses two threads to create an entwining design that looks like a masterpiece.

What you need
Watch Face
3 Large beads 8-10mm
45 Assorted smaller beads
Elastic Jewelry Thread

Instructions
I used a childhood Mickey Mouse watch I had that the strap no longer fit me. But you could even use an inexpensive store bought watch and just remove the straps.

The best thing about this design is it’s use of assorted and odd beads.

We used plastic beads, glass beads and added some jade beads for a rich expensive finish.

Cut 2 pieces of elastic thread to desired length of the total watch and add around 15cms for tying off.

Holding the 2 pieces together as one tie them around One side of the watch face. You should have an existing bar where the old watch strap was as shown in the picture below. Tie the cord around that area so it is secure.

Separate the threads and add 9 beads to each strand then place the threads together and add a large bead.

Separate the threads and add 9 beads to each strand and then place the threads together and add another large bead.

Keep doing this one more time until your beads are used up and then finish off by tying the end threads to the watch.

If your 45 beads do not reach the desired length add some extra beads, we used beads ranging from 4-7mms in size.

The key to a great watch strap is it’s color scheme, pick beads that are on the same color palette for a blended look.

Have You Seen These Ideas?

Comments


CraftBitsStaff
CraftBitsStaff
New Comment
4
CraftGossip
EditorCraftGossip
New Comment
13
CraftGossip
EditorCraftGossip
New Comment
10
CraftGossip
EditorCraftGossip
New Comment
6
Craftbits.com
EditorCraftbits.com
New Comment
8
CraftBits Staff
EditorCraftBits Staff
New Comment
4
CraftGossip
EditorCraftGossip
New Comment
5
  • 1
CraftGossip
EditorCraftGossip
New Comment
5
Craftbits.com
EditorCraftbits.com
2